Table of Contents
Advertisement
(4) As shown in the figure, fix the paper tube to the
media with tape according to the print surface
to take up, so that the print surface becomes
rolled outward.
• While raising the tension bar a little to prevent
the media from getting wrinkled, fix several
positions with tape in order in the figure.
• The figure shows the case where the media is rolled inward. When it is rolled outward,
• Surface waviness or ruck may affect the quality of currently printed image.
• If you pull the media too much when fixing with tape, the media tension may not be
21
Press
• Please leave the left switch to [AUTO].
22
Press
• Turn the switch to [AUTO]. Tension-bar lifts, taking up the media, and automatically stops at the proper
position.
• When the tension bar does not move upward even if you press the
• The media between the take-up device and carriage cannot be printed.
• If keep pressing
Take UP WRONG" is shown on the display.
fix it with tape to make it other way around.
When fixing media with tape, align the media along the direction indicated with an arrow
in the figure.
even. And, it may negatively affect the media feeding.
to take up the media to the paper tube.
to lift the tension-bar up and to stretch the loosened media.
switch, stretch the slack media by operating the switch.
(1) Set the switch to the take-up direction of the media, and turn the switch to
[MANUAL]. (The tension-bar is lifted.)
• When the media is fed and the tension-bar is not lifted, turn the switch to the
other side.
(2) When the tension bar arm becomes parallel with the floor, turn the switch to [AUTO]
to stop the tension bar.
(3) Turn the switch to the take-up direction of the media.
while the media is not attached to VTTS, the error message "ERROR425
Setting a Media
2-17
1
2
4
5
6
Advertisement
Table of Contents
