Table of Contents
Advertisement
4
Set the roll shaft with the paper core on the take-up device, and close the covers on
the right and left sides of the roll shaft.
• Fitting the A part of the roll shaft to the B part bearing of the machine, put it on.
• After closing the cover, slide the AMF lock to the locking position and tighten the cover fixing screw.
(1)
5
Fix the roll holder.
• The roll holders are at both of right and left. Fix both with the procedures below.
(1) While lifting the lever of the roll holder stopper, rotate it
to the position indicated in the figure.
(2) Get off of the lever once, and rotate it to the direction
indicated in the figure to tighten it.
(3) Repeat the Step (1) and (2) to lock the roll holder.
(2)
B part
A part
Setting a Media
Roll holder
stopper
Tighten it by
rotating
clockwise.
2-9
1
2
4
5
6
Advertisement
Table of Contents
