Table of Contents
Advertisement
Setting a narrow roll media
When you use narrow roll media (up to 1m), set the media on the narrow roll holder.
When using the media take-up machine, be careful about the points below:
• At the feeding side, set the printed surface to "revoluted" (inside out).
• At the take-up side, set the printed surface to "involuted". (If you set it to "revoluted", it may adversely
affect the media feeding.)
1
Remove the take-up VTTS at the front of the machine.
(1) Remove the adjuster stand adjusting the take-up VTTS height.
(2) Remove the clamp at both sides of the take-up VTTS.
(3) Hold the handle and pull it to the front.
2
Fix the tension bar of the rear surface side on the
locking position.
• The tension bar lock is on the left side of the machine rear
surface. Raise the tension bar and fix it with the lock.
• Be sure to handle the tension-bar gripping
outside of the lock. Gripping other parts, your
hand may get stuck in.
Handle
Adjuster stand
Lock position
Setting a Media
Clump
Lock
Tension bar
2-21
1
2
4
5
6
Advertisement
Table of Contents
