Table of Contents
Advertisement
Message
E R ROR 6 2 0
P O S I T I V E P . N o t E n o u g h
E R ROR 6 2 1
P O S I T I V E P .
O V E R
E R ROR 6 2 7
I N S E R T C A R T R I DG E
E R ROR 6 3 7
I N K L E A K 1 - -
E R ROR 6 4 9
N E G A T I V E P . A D J U S T
E R ROR 7 0 2
T H E RM I S T OR
E R ROR 7 0 7
! H 1 H E A T E R B R E A K
E R ROR 7 1 4
I N K H E A T E R COM E R R
E R ROR 7 1 5
I n k H e a t e r H T h r : 1 2 3 4 5 6
E R ROR 7 1 5
I n k H e a t e r L T h r : 1 2 3 4 5 6
E R ROR 7 1 6
I n k H e a t e r H T m p : 1 2 3 4 5 6
E R ROR 7 1 6
I n k H e a t e r L T m p : 1 2 3 4 5 6
Cause
The positive pressure cannot be kept
properly.
There is a slot in which the ink bottle
has not been inserted more than a cer-
tain time.
The ink leakage is detected in the ink
supply path.
Pressure needs to be adjusted.
The thermistor of a heater is defective.
A head heater is disconnected.
There was a communication error in the
ink heater relay board.
The ink heater thermistor is defective.
The ink heater is too hot.
• If the temperature continues to rise,
the print is cancelled and control
becomes impossible.
Warning / Error Messages
Solution
• Perform
"PRESSURE
(
P.5-7) of the maintenance. If you
cannot adjust it to the normal value, or,
even if you perform, it may be displayed,
contact your local distributor to call for
service.
Set an ink bottle.
• Turn off the main power to the machine
and turn it on after a while.
If the same error message appears
again, contact your local distributor to call
for service.
• Perform
"PRESSURE
(
P.5-7) of the maintenance. If you
cannot adjust it to the normal value, or,
even if you perform, it may be displayed,
contact your local distributor to call for
service.
• Turn off the main power to the machine
and turn it on after a while.
If the same error message appears
again, contact your local distributor to call
for service.
• Turn off the main power to the machine
and turn it on after a while.
During startup, the following message is
displayed.
I N K H E A T E R CON T RO L
C A N C E L <
> S T A R T
Press the
key and start ink heater
control.
If the same error message appears again,
contact your local distributor to call for service.
• Turn off the main power to the machine
and turn it on after a while.
If the same error message appears
again, contact your local distributor to call
for service.
• Turn off the main power, and wait an hour
or more before turning it back on.
If control became impossible after the
error was displayed, the following mes-
sage is displayed.
I N K H E A T E R CON T RO L
C A N C E L <
> S T A R T
Press the
key and start ink heater
control.
If the same error message appears again,
contact your local distributor to call for service.
ADJUST"
1
ADJUST"
1
1
1
5
5-19
Advertisement
Table of Contents
