Table of Contents
Advertisement
List of Functions
This section describes the overview of each function to be set and set values that can be registered in user types.
• About default "HOST" function
You can operate this by the setting value specified in RIP software.
When you set to other than "HOST", it operates by that setting value, not by the instruction from RIP software.
Depending on RIP software, there are some functions that cannot be instructed by software. In such a
case, it operates by the setting value of "When no instruction from RIP exists".
• For the specifying method with the RIP software, refer to the operation manual of the RIP software.
Function name
FEED COMP. (
P.2-34)
DROP. POS CORRECT
(
P.2-36)
MEDIA
HEATER
HEATER
(
P.2-28)
INK HEATER
LOGICAL SEEK(
P.3-5)
INK LAYERS (
P.3-20)
LEFT
MARGIN
(
P.3-6)
RIGHT
HOST
PATTE
UV MODE
RN
(
P.3-7)
MANU
AL
FULL
CONT
ROL
PRINT
REFRESH (
)
P.3-20
VACUUM (
P.3-20)
FEED SPEED (
P.3-20)
3-2
Set value
-9999 ~ 0 ~ 9999
-40.0 ~ 0 ~ 40.0
OFF/ 20 to 60°C
PRE
(OFF/ 68 to 140°F)
OFF/ 20 to 60°C
PRINT
(OFF/ 68 to 140°F)
OFF/ 20 to 70°C
POST
(OFF/ 68 to 158°F)
Standby
Switcho
NONE, 0 to 60min
verTIM
HOST / ON / OFF
HOST /1 to 9
HOST / -10 to 85mm
(1mm unit)
HOST / -10 to 85mm
(1mm unit)
HOST / MANUAL
-50 to +50%
LED UV
PATTERN A to F,
LAMP
Lv1 to 10
POST
CURE
ON/OFF
UV LAMP
LAMP
0 to 180mm
POS
HOST / Lv.0 (Refresh
interval long) ~ 3 (Refresh
interval short)
HOST / STANDARD /
STRONG
HOST / 10 ~ 200%
When no instruction
Default
from RIP exists
0
0
OFF
OFF
OFF
2min
HOST
ON
HOST
1
HOST
0 mm
HOST
0 mm
HOST
Operates with the
manual settings of
LED UV lamp,
0％
Pattern A, Lv10,
Post cure UV
lamp and ON
PATTERN A
Lv5
ON
0mm
Lv.3
HOST
HOST
STANDARD
*2
HOST
100%
Outline
*1
Used to print a pattern for
correcting a media-feeding
rate and correct it.
Used to adjust the dot
position in go and return
printing.
Sets heater conditions.
Sets the movement time until
the head heater and ink
heater standby status.
Sets the scan movable area
during printing.
Sets the number of layers in
which ink is to be applied.
Sets a non-printing area
along the right and left edges
of the media.
Sets and adjusts the intensity
of the UV lamp.
Sets the light control method
for the UV lamp.
Refreshes the print heads
during printing.
Sets the absorbability of the
media.
Changes the media feeding
speed in printing.
Advertisement
Table of Contents
