Controlling Access To The Wireless Network - Ruckus Wireless ZoneFlex 2741 User Manual

Configuring the Access Point
Configuring Wireless Settings
Figure 30. Limit per station traffic rates on a specific WLAN

Controlling Access to the Wireless Network

Access Control enables you to specify the stations are allowed to join (associate with)
your wireless networks. Access controls can be configured for each WLAN from its
respective Wireless # tab.
Access Control Options
This section describes the options that you can use to control access to the wireless
network.
Disabling WLAN Access Restrictions: If you select Disable WLAN access restric-
■
tions, then MAC-address-based restrictions on which stations can join the WLAN
are disabled; thus, any station can join. If the WLAN uses encryption, then the
station must still supply the correct encryption passphrase. The Access Controls
table is hidden if the current mode is Disable WLAN access restrictions.
Allowing Only Stations Listed in the Access Control Table: If you select Allow
■
only stations listed in the Access Control Table, then stations entered into the
access-controls table are allowed but all others are disallowed. To add MAC
addresses, see "Changing the Access Controls for a WLAN"
Denying Only Stations Listed in the Access Control Table: If you select Deny
■
only stations listed in the Access Control Table, then stations entered into the
access-controls table are disallowed but all others are allowed. To add MAC
addresses, see "Changing the Access Controls for a WLAN"
on page 63.
on page 63.
62