Pointing The Ap To Flexmaster - Ruckus Wireless ZoneFlex 2741 User Manual

Table 26 lists the TR-069 status information that the AP provides.
Table 26. TR-069 status information
Status Information Description
Currently using Shows the FlexMaster server IP address or URL with which the
AP is currently registered
Last Attempted Shows the date and time of the AP's last attempt to contact
Contact FlexMaster. Date and time are specified in GMT (or UTC),
which are accurate if a Network Time Protocol (NTP) server is
configured.
Last Successful Shows the date and time of the AP's last successful contact
Contact with FlexMaster.
Last Contact Result Shows the result of the last attempt to contact FlexMaster
(success or failure, and failure error code if applicable).
Current Time Shows the current date and time as known to the AP. This
timestamp is accurate if an NTP server is configured on the AP.
If there is no NTP server configured, this timestamp is useful
as a reference for comparison of the timestamps for Last
attempted contact and Last successful contact.

Pointing the AP to FlexMaster

Your ZoneFlex AP is required to "call home" to register with your FlexMaster;
FlexMaster does not initiate initial contact. To register successfully with FlexMaster,
your ZoneFlex AP must know the FlexMaster server's URL, thus entered on the AP. You
will need TCP ports 80 and 443 between APs and FlexMaster when traversing Layer
3/firewall boundaries.
To point the AP to FlexMaster
1. Go to Administration > Management.
2. Under TR-069/SNMP Management Choice, click Auto.
3. In FlexMaster Server URL, type the URL of the FlexMaster server.
4. Toggle the Contact FlexMaster every drop-down list to select how frequently
the AP will check the FlexMaster server for any pending configuration changes
available for that ZoneFlex unit. On the FlexMaster side, this field is referred to as
the Periodic Inform Interval.
5. Click Update Settings to save your changes.
After the AP registers with FlexMaster, this Administration > Management page
will show the communication status between the AP and FlexMaster.
Managing the Access Point
Enabling Other Management Access Options
89