True CS400 Owner's Manual page 15

CHAPTER 2: ASSEMBLY INSTRUCTIONS
ELLIPTICAL ASSEMBLY STEPS (continued):
STEP 2: Attach Drawbars:
a) Slide the top of the draw bars onto
the exposed shaft and use the bolts,
lock washers and flat washers from
bag 2 to secure the push rod.
Hardware Required (Bag 2):
2 M10 Bolts 2 Flat Washers
2 Lock Washer
b) Attach the bottom of each draw
bar to rear crank with M8 x 12mm
bolts.
Hardware Required (Bag 2):
8 M8x12mm Bolts
c) Use the remaining hardware in
bag 2 to attach the drawbar covers.
Hardware Required (Bag 2):
6 M3x12 Screws
8 M5x12mm Screws
Truefitness.com / 800.426.6570 / 636.272.7100
3 M3x12 Screws
2 M5x10 Screws
11