Flap Servo Installation - Carf-Models SIAI Marchetti SF-260 Construction Manual

CARF-Models

1.2.2. Flap servo installation

The only difference being that the linkage
passes within the wing panel, the servo
arm oriented to the inside.
The linkage runs direct from the servo to the
flap horn. A passageway must be ground in
the visible part of the rear spar where the
linkage is to emerge.
Attention!
Make sure that the clevis/linkage does not
rub or catch on any part of the airframe!
With the previous steps completed, and before the mounted servos on their hatches are
finally screwed in place, all extension leads to the servos (and optional lighting) must be fed
from the root rib to their corresponding end locations..
SIAI Marchetti SF-260 www.carf-models.com
Installation of the flap servos follows the same
procedures as the aileron servos, including
orientation.
The flap horn is factory pre-installed.
- 18 -