Carf-Models SIAI Marchetti SF-260 Construction Manual page 31

CARF-Models
With the first "dress rehearsal", it may be found that the length of the gear/wheel-well is a bit
short. If this is the case, the curved base of the wheel opening can be ground a bit "longer".
This should be done with a hand file or a rounded sandpaper block (do not use a power
grinder). Better to cut away a little at a time as too much at once!
Check that the gear leg has equal spacing
from the well walls when in the retracted
state.
If needed, a washer (spacer) can be
inserted between the gear and the
bulkhead.
SIAI Marchetti SF-260 www.carf-models.com
When making the cutout, be sure to
take into account the movement of the
servo with the gear leg!
- 30 -