Carf-Models SIAI Marchetti SF-260 Construction Manual page 18

CARF-Models
All parts needed for control surface hook-
up is included in the accessory pack. For
determining pushrod lengths and centering
the servo arms, it is suggested to use the
radio with receiver/battery, or an electronic
servo centering device (available at most
hobby shops/internet).
Once pushrod lengths are determined,
secure all threaded connections with
Locktite or a stop-nut.
SIAI Marchetti SF-260 www.carf-models.com
The servo opening must be opened up in order
that the servo fits cleanly. Leave enough
material in the corners to take the attachment
screws.
For the initial setup, the ailerons are secured,
centered as shown.
The servo arm screw should also be secured
with a tiny bit of thread locker (non-permanent).
- 17 -