Pneumatics Installation; Radio System/Electronics Installation - Carf-Models SIAI Marchetti SF-260 Construction Manual

CARF-Models
NOTE! Use only special, heat resistant rubber tubing
(generally included with the smoke pump kit)
between the "T" fitting and the mufflers!
Fittings (included with pump kit) must be installed to the
front of each muffler to connect the oil feed lines.

3.6.2. Pneumatics Installation

As shown in the photo before last, the retract air-supply tank is installed across the width of
the fuselage, on the bulkhead that supports the wing tube. To accomplish this, there are two
wood parts that support the air tank. To make the tank easy to remove, one of the supports
is open. Once the tank is in place, a rubber band or "O"-ring is used to secure it. The air-
tank is fitted with a FESTO fitting, making rapid hook-up easy.
Pressurizing the tank is done thru the same connection. The air-line is fitted with a "T"
coupler with one side going to the fill valve and the other to the air control valve.
Please refer to the air-control valve manufacturer instruction sheet for the correct air line
hook-up.

3.6.3 Radio System/Electronics Installation

To this theme, we cannot provide definitive installation instructions as the builder is
bound to the radio make and electronics at his disposal.
SIAI Marchetti SF-260 www.carf-models.com
For the Moki installation, the oil-
feed line is routed above the nose-
gear unit, into the engine
compartment, and from there to
each muffler ("T" or "Y" fitting).
- 37 -