General Information - Rinnai Symmetry RDV3600 Operation Manual

General information

Before operation
Read these instructions to get an overview of how to operate, maintain and service your
Rinnai Symmetry RDV3600.
Cladding and finishes
The Symmetry RDV3600 comes in two framing options; framed and frameless. Framed is best
suited to a dry wall/plaster finish, the frameless option suits cladding with a finished edge such
as tiles, brick or polished granite. Both options are shown below to highlight the difference.
Framed
With the framed and frameless installation the fire is a permanent fixture. The fire is screwed
to the framing before the cladding. Once the cladding has been fixed in place the Symmetry
RDV3600 has been framed into a permanent position.
The depth of the Symmetry RDV3600 is adjustable to accommodate a range of cladding
options. This is important for a frameless installation to achieve a flush finish. Where the edge
is visible an aluminium edge can be used to hide the visible cladding.
electrical connection
The standard electrical connection is to the right hand side of the heater front
assembly. If necessary this can be changed by your electrician to terminate on the left.
the connection is either direct wired or connected to a power point within the cavity.
A 1500 mm power cord is supplied with a 3-pin plug. This must be connected to a dedicated
earthed power point. the electric isolation switch must be accessible after the appliance has
been installed.
The heater must not be located immediately below a socket outlet (potential fire hazard).
If the supply cord is damaged, it must be replaced by a licensed tradesperson. This must be a
genuine replacement part available from Rinnai, part number 6765B.
Rinnai new Zealand RDV3600 Operation Manual: 11743-A
9
Frameless
01-10