Clearances - Rinnai Symmetry RDV3600 Operation Manual

Clearances

the appliance must not be installed where curtains or other combustible materials could come
into contact with the heater. In some cases curtains may need restraining.
the clearances listed below are minimum clearances unless otherwise stated. there are further
details on mantel and surround clearances on the next page.
4 0 0
0
1
Up-wall installations
If the Symmetry is being installed up the wall and close to the ceiling, the recommended
minimum clearance is 1000 mm.
Non-combustible cladding
Non-combustible cladding such as 9 mm Eterpan MD
the appliance and 400 mm in height) to be installed directly above the fire as shown. This is
required due to high temperatures in this area.
Floor protection
Heat emanating from this fire may over time affect the appearance of some materials used for
flooring, such as, carpet, vinyl, cork or timber. This may be amplified if the air
contains cooking vapours or cigarette smoke.
To avoid this occurring, it is recommended that a mat be placed in front of this
appliance.
9mm eterpan MD (medium density) is supplied by PBS Ltd (www.pbs.co.nz). Other materials may also be
1
suitable, please seek advice from a cladding supplier as to the correct application and specification of the material.
Rinnai new Zealand
To ceiling
4 0 0
0
0
(extending at least the full width of
1
RDV3600 Operation Manual: 11743-A
7
01-10