Clearing Mishandled Forms; Jam In Folder - Pressure Seal Group PS 600 Operator's Manual

5. Operation Errors

Clearing mishandled forms

Jam in folder

If the 'Jam in folder' error message is displayed, proceed as follows:
1. Switch off the mains power and unplug from the mains and then remove the
top cover (see page ).
2. Remove the fold plates using the procedure described on page 15.
3. Lift the two snap levers holding the top-folding roller in place, (see Figure ) and
lift out the top folding roller.
4. Remove the jammed form.
5. Replace the top-folding roller.
The flat faces on the two end bearings must be held vertically for them to drop
into the housing slots. Close the two snap levers to hold the roller in place.
6. Replace the fold plates
7. Replace the top cover and restore the mains power
8. Reload and restart the machine
Page 32
PS 600
22-01-03 Iss. B.