Z Fold Set-Up - Pressure Seal Group PS 600 Operator's Manual

3. Set-up

Z fold set-up

Refer to Figure 9.
1. Measure the length of the folds required.
2. Adjust the form stop for each folding plate to the measurement you determined
previously in step 1 as follows:
Loosen the locking knob at the centre of the form stop.
Slide the stop along the rods until the stop aligns with the correct settings on
the scales. Use the fine adjustment control to make sure the scales on each
side of the folding plate show the same settings otherwise the form will not fold
squarely.
Tighten the locking knob.
3. If the new form is a different width from the last form used, refer to 'Adjusting
the form guides' on page 22.
4. Re-install both folding plates.
Page 20
PS 600
22-01-03 Iss. B.