Setting Up The Form Conveyor - Pressure Seal Group PS 600 Operator's Manual

PS 600

Setting up the form conveyor

The form conveyor collects the forms from the out-feed and stacks them (either
overlapping or separated) ready for removal. To fit and set-up the conveyor, proceed as
follows:
1. Clip the conveyor over the locating lip on the out-feed of the machine, plug it in
to the mains output socket (see Figure 12) and turn it on.
2. Loosen the securing screw and adjust the entrapment roller according to the
form size (close to out-feed for short forms; further away for larger forms).
3. Adjust the overlap control as required (0 = most overlap; 10 = greatest
separation).
Locating
Lip
Locating
Clip
(x2)
Figure 12: Conveyor Setup
22-01-03 Iss. B.
Mains Output
Socket
Overlap
Control
Entrapment Entrapment
Roller Roller
Securing
Screw
3. Set-up
Page 23