Operator Controls; Lcd Display; On/Start Button - Pressure Seal Group PS 600 Operator's Manual

PS 600

Operator controls

LCD display

The forms counter on the LCD display indicates the number of forms in the current run
(since it was last reset) and is zeroed by pressing the reset button (see Figure 5).
There is an additional counter located inside the machine indicating the cumulative
total. This can only be accessed by a service engineer.
The LCD display also indicates any error messages (see page 31) and the machine's
current status e.g. Ready, Running, software version, etc.
Reserved for
On/Start
Off/Stop
Speed Control Slider
Slower
Figure 5: Operator controls

On/Start Button

The On/Start button switches the machine on and also performs the following:
•
Momentarily pressing the run switch processes one form.
•
Pressing and holding the run switch for two seconds starts the continuous processing
of all the forms
22-01-03 Iss. B.
future use
+
Reserved for
future use
Engineering
Feature Button
Faster
2. Features
Reset
Button
Page 9