Operation Errors; Error Conditions - Pressure Seal Group PS 600 Operator's Manual

5. Operation Errors

Error Conditions

In the event of a problem existing that prevents the machine from operating, a suitable
error message will be shown on the LCD display as follows:
INFEED JAM:
JAM IN FOLDER:
JAM AFTER FOLDER:
JAM IN SEALER:
SEALER ERROR:
JAM AT EXIT:
22-01-03 Iss. B.
Paper cannot enter the machine correctly. Make sure that the
infeed table is set up properly.
There are too many forms in the folder. Take out the top fold
plate and try to pull any visible forms out or turn the hand
wheel. Then try to jog the remaining pieces of paper out.
Paper has built up between the folder and the sealer. Take
out the top fold plate and remove any paper visible between
the folder and the sealer. Then try jogging the rest of the
paper out. The machine will not jog if there is paper covering
the mid-sensor.
Forms are stuck in the sealer, back the sealer bolts off and
try to jog the excess paper out.
There is more than one form under the sealer rollers, which
can no longer turn. Back the sealer off by loosening the bolts
and then jog the machine by pressing stop and start
simultaneously.
Forms are not exiting the sealer correctly, make sure the
conveyor is set up properly and try to jog any excess forms
out.
Page 31