Removing/Fitting The First Folding Plate - Pressure Seal Group PS 600 Operator's Manual

3. Set-up

Removing/fitting the first folding plate

1. Lift the Folding Plate Cover and release the two Locking Arms (see Figure 6).
2. Remove the Folding Plate by sliding it towards the rear of the machine.
3. Fitting the Second Folding Plate is the reversal of the above procedure.
Folding Plate
Cover
Figure 6: Removing the first folding plate
Page 14
Locking Arms
(1 each side)
First Fold
Plate
PS 600
22-01-03 Iss. B.