Jam After Folder - Pressure Seal Group PS 600 Operator's Manual

PS 600

Jam after folder

If the 'Jam after folder' error message is displayed, proceed as follows:
1. Remove all forms from the in-feed tray.
2. Momentarily press the run switch to eject the mishandled form out of the
rollers.
If the form doesn't eject, repeat step 2. It may take several attempts.
If, after several attempts, the mishandled form doesn't eject, carry out the
Pressure bolt release procedure on page 34.
It may be necessary to stabilise the forms before folding and sealing them.
This can be achieved by allowing them to rest in the same room as the
machine for an hour or more after printing.
3. When the jammed form is removed from the sealer, check the sealer rollers for
any form particles that may have become stuck with adhesive.
22-01-03 Iss. B.
5. Operation Errors
Page 33