Clearing Mishandled Documents; When The Stop Light Flashes; If It Is In Either The First Or Second Fold Plate - Pressure Seal Group PS 100 Operator's Manual

5. Operation Errors

Clearing Mishandled Documents

When the stop light flashes

To clear a flashing error condition:
•
Switch off the mains power and unplug from the mains.
•
Remove the lid and locate the form that is jammed.

If it is in either the first or second fold plate:

Remove the fold plate in question by using the following procedure:
•
Lift off the first fold plate as follows:
a) Lift up the left hand edge of the plate until it releases from the left hand holding clips.
b) Pull it clear of the hook pins located under the right hand edge of the plate.
•
Remove the second fold plate as follows:
a) Lift up the right edge of the plate until it releases from the holding clips
b) Pull it clear of the hook pins under the left edge of the plate.
•
Lift the two snap levers holding the top-folding roller in place, (see figure 12) and lift
out the roller.
•
Remove the jammed form.
Page 28
PS 100
14-11-02 Iss. 1.