Setting Up The In-Feed Bed - Pressure Seal Group PS 600 Operator's Manual

3. Set-up

Setting up the In-feed Bed

Set up the in-feed bed as follows:
Adjust so that air flow
causes paper to float tightly
Close all air jets outside the
Adjust backstops so that
paper can not move
backwards by more than 1mm
Adjust side beds so that paper is
held in place with no more than
1mm of sideways movement
Turn to adjust air
flow onto in-feed bed
Figure 11: Setting up the In-Feed Bed
Page 22
on in-feed bed
paper stack
Turn to adjust
back stop
Turn to adjust
distance of seperator
block from mounting
bar
Turn to adjust paper
infeed angle
Adjust so that the vacuum pickup point
aligns with the seperator block
Seperator block should be
approximately 4mm from mounting bar
Turn to adjust side
beds
Turn to adjust height
of seperator block
4mm
Suction roller
Vacuum pick
up point
PS 600
Height of seperator block should be 2
thickness (of the paper to be
processed)with medium friction
between the seperator block and the
suction roller
22-01-03 Iss. B.