Troubleshooting - Pressure Seal Group PS 600 Operator's Manual

5. Operation Errors

Troubleshooting

The table below lists the possible causes and any corrective actions required for
conditions that may occur with your machine. For conditions not covered below, contact
your Pressure Seal Systems distributor.
Condition
The power-on indicator
does not light.
The machine does not
operate when the On/Start
button is pressed (power
on)
Forms are mishandled in the
folder or damaged during
sealing.
Page 36
Possible Cause
Mains lead not plugged into
an AC outlet.
Mains plug fuse blown.
Board fuse blown.
Form misfeed, jam detected:
error message displayed.
No forms loaded.
Board fuse blown.
Fold plate form stop(s)
adjusted improperly.
Debris in folding plates;
folding plates not installed
properly; fold plate form
stop(s) adjusted improperly.
PS 600
Corrective Action
Plug mains lead into an AC
outlet.
Replace fuse. If the
replacement fuse blows,
contact your Pressure Seal
distributor for advice.
Contact your Pressure Seal
distributor for advice.
Clear mishandled forms.
Load forms.
Contact your Pressure Seal
distributor for advice.
Check and adjust the
position of the fold plate
form stop(s). See page 16.
Remove debris; properly
install fold plates; check
position of the fold plate
form stop(s).
22-01-03 Iss. B.