Starting Up And Testing The Machine - Pressure Seal Group PS 600 Operator's Manual

PS 600

Starting up and testing the machine

This procedure describes how to start up and test the machine to make sure it is ready to
fold and seal your forms. Always perform this procedure at the start of each form
processing session to ensure the best results.
Before you start up and test the machine, make sure all of the following conditions are
satisfied:
•
The folding plates are adjusted and installed properly for the fold you want.
•
The form guides are set correctly to provide enough, but not too much, clearance at
the sides of the form stack
•
Forms are properly loaded and the Ready message is shown on the LCD display.
22-01-03 Iss. B.
4. Operation
Page 27