Removing/Fitting The Second Folding Plate - Pressure Seal Group PS 600 Operator's Manual

PS 600

Removing/fitting the second folding plate

1. Lift and remove the Small Top Cover (see Figure 7) then raise the In-Feed Bed,
ensuring it is locked into the upright position with the locking arm.
2. Fold down the Front Panel, release the two Locking Arms and then slide the
First Folding Plate out of the machine.
3. Fitting the First Folding Plate is the reversal of the above procedure.
Small Top Cover
In-Feed Bed
Second Fold
Plate
Figure 7: Removing the second folding plate
22-01-03 Iss. B.
Locking Arms
(1 each side)
3. Set-up
Front
Panel
Page 15