Loading Forms - Pressure Seal Group PS 600 Operator's Manual

4. Operation

Loading forms

1. When you load forms make sure:
•
There are no mishandled forms in the folder or sealer (no error messages
indicated on the LCD display - see Error Conditions on page 31).
•
All rubber and metal rollers are clean and free of foreign matter
2. Fan the stack of forms to make sure they are not sticking together.
3. Align the stack so the forms feed correctly into the machine. Form orientation
depends upon form design, the type of fold desired, presence of curl, and how
the folding plates are set up.
4. Align the stack of forms so that the ends and sides of the stack are smooth and
square.
5. Feed the stack between the form guides and into the machine until the stack
meets the guide plate.
6. Make sure the 'Ready' message is shown on the LCD display, indicating the
stack is properly loaded on the in-feed tray.
7. Make sure the stack of forms is flat and not bowed due to the form guides
being too tight.
Page 26
PS 600
22-01-03 Iss. B.