Table of Contents
Advertisement
PS 100
Power requirements
The PS100 must be operated from the type of power source indicated on the marking
label. If you are unsure of the type of power available, consult your Pressure Seal
representative or local power company.
If an extension lead is used with the PS100, make sure that the total of the ampere
ratings of the products plugged into the extension lead does not exceed the extension
lead ampere rating.
If the machine is damaged
Unplug the machine from the wall outlet and refer servicing to qualified personnel under
the following conditions:
If the mains lead is damaged or frayed
If liquid has been spilled into the machine
If the machine has been exposed to rain or water
If the machine has been dropped or damaged
If the machine does not operate normally when the operating instructions are
followed. Adjust only those controls that are covered by the operating instructions,
since improper adjustment of other controls may result in damage.
If the machine exhibits a distinct change in performance, indicating a need for a
service
14-11-02 Iss. 1.
1. Introduction
Page 5
Advertisement
Table of Contents
