Replacing The Folding Plates; First Fold Plate; Second Fold Plate - Pressure Seal Group PS 100 Operator's Manual

PS 100
3. Set-up

Replacing the folding plates

The PS100 may be set for C, V or Z fold forms. The fold plates used determine the fold type.

First fold plate

Insert the fold plate by identifying the locating pins nearest the fold roller and hooking the
plate onto the pins, ensuring that both the hooks locate onto both the pins on either side
of the machine. Lay the fold plate flat and push the edge down until the fold plate clicks
firmly into position.

Second fold plate

For C and Z folds, locate the pins nearest the fold roller and hook the plate onto the pins,
making sure that both hooks locate onto each pin either side of the machine. Lay the fold
plate flat and push the edge down until the fold plate clicks firmly into position. For V
folds only, the second fold plate should be located with the hooks on the same pins near
the fold roller, but with the plate rotated through 180 . Lay the fold plate flat and push the
edge down until it locks firmly into position above the first fold plate.
Figure 10: Adjusting the form guides
Page 19
14-11-02 Iss. 1.