Section 2 - Getting Started; Administrator's Computer Requirements - D-Link DWL-2600AP Administrator's Manual

Unified Access Point Administrator's Guide

Section 2 - Getting Started

The D-Link DWL-x600AP unified access point (UAP) provides continuous, high-speed access between wireless
devices and Ethernet devices. It is an advanced, standards-based solution for wireless networking in businesses of
any size. The UAP enables wireless local area network (WLAN) deployment while providing state-of-the-art wireless
networking features.
The UAP can operate in two modes: Standalone Mode or Managed Mode. In Standalone Mode, the UAP acts
as an individual access point in the network, and you manage it by using the Administrator Web User Interface
(UI), command-line interface (CLI), or SNMP. In Managed Mode, the UAP is part of the D-Link Unified Wired and
Wireless System, and you manage it by using the D-Link Unified Wireless Switch. If an AP is in Managed Mode, the
Administrator Web UI, Telnet, SSH, and SNMP services are disabled.
This document describes how to perform the setup, management, and maintenance of the UAP in Standalone Mode.
For information about configuring the AP in Managed Mode by using the D-Link Unified Wireless Switch, see the User
Manual for the switch.
Before you power on a new UAP, review the following sections to check required hardware and software components,
client configurations, and compatibility issues. Make sure you have everything you need for a successful launch and
test of your new or extended wireless network.
The DWL-6600AP and DWL-8600AP are dual-radio access points and support the IEEE 802.11a, 802.11b, 802.11g,
and 802.11n modes. The DWL-2600AP and DWL-3600AP are single-radio access points and support the IEEE
802.11b, IEEE 802.11g, and 802.11n (2.4 GHz) modes.
This section contains the following topics:
•) "Administrator's Computer Requirements" on page 11
•) "Wireless Client Requirements" on page 12
•) "Dynamic and Static IP Addressing on the AP" on page 13
•) "Installing the UAP" on page 13
•) "Basic Settings" on page 16
•) "Using the CLI to View the IP Address" on page 17
•) "Configuring the Ethernet Settings" on page 18
•) "Configuring IEEE 802.1X Authentication" on page 19
•) "Verifying the Installation" on page 20
•) "Configuring Security on the Wireless Access Point" on page 21
To manage the UAP by using the Web interface or by using the CLI through Telnet or SSH, the AP needs an IP
address. If you use VLANs or IEEE 802.1X Authentication (port security) on your network, you might need to configure
additional settings on the AP before it can connect to the network.
Note: The WLAN AP is not designed to function as a gateway to the Internet. To connect your
WLAN to other LANs or the Internet, you need a gateway device.

Administrator's Computer Requirements

The following table describes the minimum requirements for the administrator's computer for configuration and
administration of the UAP through a Web-based user interface (UI).
Required Software or Component
Serial or Ethernet Connection to the
Access Point
January 2015
Description
The computer used to configure the first access point must be connected
to the access point by a serial cable or an Ethernet cable.
Section 2 - Getting Started
Unified Access Point Administrator's Guide
Page 11