Configuring The Ethernet Settings; Using The Cli To Configure Ethernet Settings; Figure 4 - Command Line Interface (Cli) Connection - D-Link DWL-2600AP Administrator's Manual

Unified Access Point Administrator's Guide

Configuring the Ethernet Settings

The default Ethernet settings, which include DHCP and VLAN information, might not work for all networks.
By default, the DHCP client on the UAP automatically broadcasts requests for network information. If you want to
use a static IP address, you must disable the DHCP client and manually configure the IP address and other network
information.
The management VLAN is VLAN 1 by default. This VLAN is also the default untagged VLAN. If you already have
a management VLAN configured on your network with a different VLAN ID, you must change the VLAN ID of the
management VLAN on the access point.
For information about using the Web interface to configure the Ethernet settings, see
35. You can also use the CLI to configure the Ethernet settings, which the following section describes.

Using the CLI to Configure Ethernet Settings

Use the commands shown in the following table to view and set values for the Ethernet (wired) interface. For more
information about each setting, see the description for the field in the following table.
Action
Get the DNS Name
Set the DNS Name
Get Current Settings for the Ethernet (Wired) Internal
Interface
Set the management VLAN ID
View untagged VLAN information
Enable the untagged VLAN
Disable the untagged VLAN
Set the untagged VLAN ID
View the connection type
January 2015

Figure 4 - Command Line Interface (CLI) Connection

Commands
get host id
set host id <host_name>
For example:
set host id lab-ap
get management
set management vlan-id <1-4094>
get untagged-vlan
set untagged-vlan status up
set untagged-vlan status down
set untagged-vlan vlan-id <1-4094>
get management dhcp-status
Section 2 - Getting Started
"Ethernet Settings" on page
Unified Access Point Administrator's Guide
Page 18