Configuring Ieee 802.1X Authentication - D-Link DWL-8500AP - AirPremier AG Wireless Switching 108 Dualband Access Point Administrator's Manual

D-Link Unified Access Point Administrator's Guide
Table 8. CLI Commands for Ethernet Settings
Action
Set DNS Nameservers to Use
Static IP Addresses (Dynamic to
Manual Mode)
Set DNS Nameservers to Use
DHCP IP Addressing (Manual to
Dynamic Mode)
In the following example, the administrator uses the CLI to set the management VLAN ID to
123 and to disable untagged VLANs so that all traffic is tagged with a VLAN ID.
DLINK-WLAN-AP# set management vlan-id 123
DLINK-WLAN-AP# set untagged-vlan status down
DLINK-WLAN-AP# get management
Property
------------------------------
vlan-id
interface
static-ip
static-mask
ip
mask
mac
dhcp-status
DLINK-WLAN-AP# get untagged-vlan
Property
---------------
vlan-id
status
DLINK-WLAN-AP#

Configuring IEEE 802.1X Authentication

On networks that use IEEE 802.1X port-based network access control, a supplicant (client)
cannot gain access to the network until the 802.1X authenticator grants access. If your network
uses 802.1X, you must configure 802.1X authentication information that the AP can supply to
the authenticator.
34 © 2001-2008 D-Link Corporation. All Rights Reserved.
Command
set host dns-via-dhcp down
set host static-dns-1 <ip_address>
set host static-dns-2 <ip_address>
Example:
set host static-dns-1 192.168.23.45
set host dns-via-dhcp up
Value
123
brvlan123
10.90.90.91
255.0.0.0
10.254.24.43
255.0.248.0
00:02:BC:00:14:E8
up
Value
1
down