Client Qos Status; Figure 62 - Qos Configuration Status For Associated Clients; Table 55 - Diffserv Policy Map - D-Link DWL-2600AP Administrator's Manual

Unified Access Point Administrator's Guide
Field
Drop
Mark Class of
Service
Mark IP DSCP
Mark IP Precedence
Disassociate Class
Map
Member Classes
Delete Policy Map
To delete a Policy Map, select the Delete Policy Map option and click Apply.

Client QoS Status

The Client QoS Status page shows the client QoS settings that are applied to each client currently associated with
the AP.
To view QoS settings for an associated client, click the Client QoS Status tab.
Field
Station
Global QoS Mode
Client QoS Mode
Bandwidth Limit Up
Bandwidth Limit
Down
January 2015
Description
Select Drop to specify that all packets for the associated traffic stream are to be dropped if
the class map criteria is met.
Select this field to mark all packets for the associated traffic stream with the specified class
of service value in the priority field of the 802.1p header. If the packet does not already
contain this header, one is inserted. The CoS value is an integer from 0 – 7.
Select this field to mark all packets for the associated traffic stream with the IP DSCP value
you select from the list or specify.
Select from List
Select from a list of DSCP types.
Match to Value
Enter a DSCP Value to match (0 – 63).
Select this field to mark all packets for the associated traffic stream with the specified IP
Precedence value. The IP Precedence value is an integer from 0 – 7.
Select this option and click Apply to remove the class selected in the Class Map Name
menu from the policy selected in the Policy Map Name menu.
Lists all DiffServ classes currently defined as members of the selected policy. If no class is
associated with the policy, the field is empty.
Select this field to delete the policy map showing in the Policy Map Name menu.

Table 55 - DiffServ Policy Map

Figure 62 - QoS Configuration Status For Associated Clients

Description
The Station menu contains the MAC address of each client currently associated with the AP.
To view the QoS settings applied to a client, select its MAC address from the list.
Shows the current Client QoS Global Admin Mode on the AP.
Shows whether the QOS mode for the selected client is enabled or disabled.
Note: For the Qos Mode to be enabled on a client, it must be globally enabled on the AP
and enabled on the VAP the client is associated with. Use the VAP QoS Parameters page
to enable the QoS Global Admin mode and the per-VAP QoS Mode.
Shows the maximum allowed transmission rate from the client to the AP in bits per second
(bps). The valid range is 0 – 4294967295 bps.
Shows the maximum allowed transmission rate from the AP to the client in bits per second
(bps). The valid range is 0 – 4294967295 bps.
Section 8 - Configuring Client Quality of Service (QoS)
Unified Access Point Administrator's Guide
Page 101