Appendix A - Default Ap Settings - D-Link DWL-2600AP Administrator's Manual

Unified Access Point Administrator's Guide

Appendix A - Default AP Settings

When you first power on a UAP, it has the default settings shown in the following table.
Feature
System Information
User Name
Password
Ethernet Interface Settings
Connection Type
DHCP
IP Address
Subnet Mask
DNS Name
Management VLAN ID
Untagged VLAN ID
IPv6 Admin Mode
IPv6 Auto Config Admin Mode
Radio Settings
Radio (1 and 2)
Radio 1 IEEE 802.11 Mode
Radio 2 IEEE 802.11 Mode
802.11a/n Channel
802.11b/g/n Channel
Radio 1 Channel Bandwidth
Radio 2 Channel Bandwidth
Primary Channel
Short Guard Interval Supported
STBC Mode
Protection
Maximum Wireless Clients
Transmit Power
Legacy Rate Sets Supported (Mbps)
Legacy Rate Sets (Mbps)
(Basic/Advertised)
MCS (Data Rate) Settings
(802.11n only)
Broadcast/Multicast Rate Limiting
Fixed Multicast Rate
Beacon Interval
DTIM Period
Fragmentation Threshold
RTS Threshold
TSPEC Mode
TSPEC Voice ACM Mode
Virtual Access Point Settings
Status
January 2015
Default
admin
admin
DHCP
Enabled
10.90.90.91 (if no DHCP server is available)
255.0.0.0
None
1
1
Enabled
Enabled
One
802.11a/n
802.11b/g/n
Auto
Auto
40 MHz
20 MHz
Lower
Yes
On
Auto
200
100 percent
IEEE 802.11a: 54, 48, 36, 24, 18, 12, 9, 6
IEEE 802.11b: 11, 5.5, 2, 1
IEEE 802.11g: 54, 48, 36, 24, 18, 12, 11, 9, 6, 5.5, 2, 1
IEEE 802.11a: 24, 12, 6
IEEE 802.11b: 2, 1
IEEE 802.11g: 11, 5.5, 2, 1
0–15 Enabled
Disabled
Auto
100
2
2346
2347
Off
Off
VAP0 is enabled on both radios, all other VAPs disabled
Appendix A - Default AP Settings
Unified Access Point Administrator's Guide
Page 113