Viewing Email Alert Operational Status; Figure 15 - Email Alert Operational Status; Table 15 - Radio Statistics Information; Table 16 - Email Alert Status - D-Link DWL-2600AP Administrator's Manual

Unified Access Point Administrator's Guide
Field
Multicast Frames
Transmitted
Duplicate Frame
Count
Failed Transmit
Count
Transmit Retry
Count
Multiple Retry
Count
RTS Success Count Count of CTS frames received in response to an RTS frame.
RTS Failure Count
ACK Failure Count
FCS Error Count
Frames Transmitted Count of each successfully transmitted MSDU.
WEP Undecryptable
Count

Viewing Email Alert Operational Status

The Email Alert Operational Status page provides information about the email alerts sent based on the syslog
messages generated in the AP.
To view the Email Alert Operational Status, click the Status > Email Alert Status tab.
To configure the email alerts, see
The following table describes details about the Email Alert Operational Status.
Field
Email Alert Status
Number of Email
Sent
Number of Email
Failed
Time Since Last
Email Sent
January 2015
Description
Count of successfully transmitted MSDU frames where the multicast bit is set in the
destination MAC address.
Number of times a frame is received and the Sequence Control field indicates is a duplicate.
Number of times an MSDU is not transmitted successfully due to transmit attempts
exceeding either the short retry limit or the long retry limit.
Number of times an MSDU is successfully transmitted after one or more retries.
Number of times an MSDU is successfully transmitted after more than one retry.
Count of CTS frames not received in response to an RTS frame.
Count of ACK frames not received when expected.
Count of FCS errors detected in a received MPDU frame.
Count of encrypted frames received and the key configuration of the transmitter indicates
that the frame should not have been encrypted or that frame was discarded due to the
receiving station not implementing the privacy option.

Table 15 - Radio Statistics Information

"Configuring Email Alert" on page

Figure 15 - Email Alert Operational Status

Description
The Email Alert operational status The status is either Up or Down. The default is Down.
The total number of email sent so far. The range is an unsigned integer of 32 bits. The
default is 0.
The total number of email failures so far. The range is an unsigned integer of 32 bits. The
default is 0.
The time since the last email was sent. Time format is used. The default is 00 days 00 hours
00 minutes 00 seconds.

Table 16 - Email Alert Status

Section 3 - Viewing Access Point Status
72.
Unified Access Point Administrator's Guide
Page 34