Creating A Management Access Control List (Acl); Figure 31 - Modify 802.1X Supplicant Authentication Settings; Table 34 - Ieee 802.1X Supplicant Authentication - D-Link DWL-2600AP Administrator's Manual

Unified Access Point Administrator's Guide
Field
802.1X Supplicant
EAP Method
Username
Password
Certificate File
Status
Certificate File
Upload
Note: After you configure the settings on the Authentication page, you must click Apply to apply
the changes and to save the settings. Changing some settings might cause the AP to stop and
restart system processes. If this happens, wireless clients will temporarily lose connectivity. We
recommend that you change AP settings when WLAN traffic is low.

Creating a Management Access Control List (ACL)

You can create an access control list (ACL) that lists up to five IPv4 hosts and five IPv6 hosts that are authorized to
access the AP management interface. If this feature is disabled, anyone can access the management interface from
any network client by supplying the correct AP username and password.
January 2015

Figure 31 - Modify 802.1X Supplicant Authentication Settings

Description
Click Enabled to enable the Administrative status of the 802.1X Supplicant.
Click Disabled to disable the Administrative status of the 802.1X Supplicant.
Select one of the following EAP methods to use for communication between the AP and the
authenticator:
•) MD5
•) PEAP
•) TLS
Enter the user name for the AP to use when responding to requests from an 802.1X
authenticator.
The user name can be 1 to 64 characters in length. ASCII printable characters are allowed,
which includes upper and lower case alphabetic letters, the numeric digits, and special
symbols such as @ and #.
Enter the password for the AP to use when responding to requests from an 802.1X
authenticator.
The password can be 1 to 64 characters in length. ASCII printable characters are allowed,
which includes upper and lower case letters, numbers, and special symbols such as @ and
#.
Indicates whether a certificate file is present and when that certificate expires.
Upload a certificate file to the AP by using HTTP or TFTP:
•) HTTP — Browse to the location where the certificate file is stored and click Upload.
•) TFTP — Specify the IP address of the TFTP server where the certificate file is located
and provide the file name, including the file path, then click Upload.

Table 34 - IEEE 802.1X Supplicant Authentication

Section 4 - Managing the Access Point
Unified Access Point Administrator's Guide
Page 63