Dmx Mode; Set The Dmx Starting Address; Dmx Mode Selection; Slave Mode - Blizzard Lighting blockhead Manual

DMX Mode

Allows the unit to be controlled by any universal DMX controller.

Set The DMX Starting Address

To assign a DMX staring address to the fi xture, use the <MODE> button to scroll to Set DMX
Address, and press the <ENTER> button. Then use the <UP/DOWN> buttons to display any
value within the range of 001-512, then push the <MODE> button. You will now be presented
with the option to choose the DMX channel mode.

DMX Mode Selection

After selecting the starting DMX address as described above, now use the <UP/DOWN>
buttons to display either 16, 20, or 116 channel mode. Then push the <ENTER> button to
confi rm your choice, and the <MODE> button to return to the main menu.

Slave Mode

1.) Disconnect fi xture(s) from any DMX signal source.
2.) Set each fi xture to matching DMX modes (16, 20, or 116).
3.) Connect all fi xtures together via DMX. The fi rst fi xture in the DMX chain will be the master
fi xture, followed by the slave fi xtures.
4.) Connect DMX controller to the master unit for DMX control.

Auto, Stand-Alone, Sound Active Modes:

Allows a single or Master/Slaved units to run factory installed programs at user selectable speeds.
Auto Movement
1.) Use the <MODE> button to scroll to Set Run AUTO XY, then press the <ENTER> button.
You can now use the <UP/DOWN> buttons to select one of its 10 built-in movement programs.
Highlight within the range of P[01] to P[10] and then press the <ENTER> button to confi rm
your choice.

Built-in Programs

1.) Use the <MODE> button to scroll to Set Run AUTO LED, then press the <ENTER> button.
You can now use the <UP/DOWN> buttons to select one of its 10 built-in lighting programs.
Highlight within the range of P[01] to P[12] and then press the <ENTER> button to confi rm
your choice.
2.) You now are presented with the option to choose the speed program. Use the <UP/
DOWN> buttons to select one of its 10 speed settings. Choose a value from P[01] (fast) to
P[12] (slow), then press the <ENTER> button to confi rm your choice.

Sound Active Mode

1.) Use the <MODE> button to scroll to Set Run SOUND, then press the <ENTER> button.
You can now use the <UP/DOWN> buttons to select one of its 10 built-in sound active
programs. Highlight within the range of P[01] to P[10] and then press the <ENTER> button
to confi rm your choice.
BlockHead™ User Manual Rev. B
Page 12
(c) 2014 Blizzard Lighting, LLC