Dmx Mode; Set The Dmx Starting Address; Dmx Channel Mode; Working Selection Mode - Blizzard Lighting Blockhead II User Manual

DMX Mode

Allows the unit to be controlled by any universal DMX controller.

Set The DMX Starting Address

To assign a DMX staring address to the fixture, use the <MENU> button to scroll to DMX
Address SET, and press the <ENTER> button. Then use the <UP/DOWN> buttons to display
any value within the range of 001-512, then push the <ENTER> button.

DMX Channel Mode

To select a DMX channel mode that you wish to work in, use the <MENU> button to scroll to
Work Mode Set, and press <ENTER>. Then use the <UP/DOWN> buttons to display either
19, 29, or 117 channel mode, and push the <ENTER> button to confirm your choice.
Working Mode Selection
The default working mode is DMX512. To select a different working mode, use the <MENU>
button to scroll to DMX Address SET, and press the <ENTER> button. From here you can use
the <UP/DOWN> buttons to highlight either DMX512, Slave, Sound, Fast (fast auto), Slow
(slow auto), or Artnet, then push the <ENTER> button to confirm your choice.

Slave Mode

1.) Disconnect fixture(s) from any DMX signal source.
2.) Set each fixture to matching DMX modes (19, 29, or 117).
3.) For each fixture you want to run in slave mode, use the menu button to navigate to Work
Mode Set, and press <ENTER>. Then use the <UP/DOWN> buttons to navigate to Slave
Mode, and press <ENTER> to confirm.
4.) Connect all fixtures together via DMX. The first fixture in the DMX chain will be the master
fixture, followed by the slave fixtures.
5.) Connect DMX controller to the master unit for DMX control.

Auto, Stand-Alone, Sound Active Modes:

Allows a single or Master/Slaved units to run factory installed programs at user selectable speeds.

Auto Mode

1.) Use the <MENU> button to scroll to Work Mode Set, and press <ENTER>. Now use the
<UP/DOWN> buttons to highlight either Slow or Fast and press the <ENTER> button for
slow or fast paced auto mode.

Sound Active Mode

1.) Use the <MENU> button to scroll to Work Mode Set, and press <ENTER>. Now use the
<UP/DOWN> buttons to highlight Sound and press the <ENTER> button.

Invert Pan/Tilt

1.) Use the <MENU> button to scroll to Invert PAN or Invert Tilt, and press <ENTER>.
2.) Then use the <UP/DOWN> buttons to display either Yes or No.
3.) Press the <ENTER> button to confirm your choice.
BlockHead™ II User Manual Rev. A
Page 12
(c) 2015 Blizzard Lighting, LLC