Set The Starting Dmx Address; Select The Dmx Channel Mode; Dmx Mode; Slave Mode - Blizzard Lighting Wink Manual

DMX Mode

Allows the unit to be controlled by any universal DMX controller.

Set the Starting DMX Address:

1.) Navigate the main menu to reach DMX Settings, press <ENTER>.
2.) Highlight Set DMX Address, and press <ENTER>.
3.) Use the <UP/DOWN> buttons to select a DMX channel from 001-512.
4.) Press the <ENTER> button to confirm.

Select the DMX Channel Mode:

1.) Navigate the main menu to reach DMX Settings, press <ENTER>.
2.) Highlight Channel Mode, and press <ENTER>.
3.) Use the <UP/DOWN> buttons to select Extended (35CH), Standard
(26CH) or Basic (19CH).
4.) Press the <ENTER> button to confirm your selection.
DMX Mode:
1.) Navigate the menu until you reach Run Mode, press <ENTER>.
2.) Use the <UP/DOWN> buttons to highlight DMX, press <ENTER>.
3.) In DMX mode, the starting DMX channel is shown prominently in the center of
the screen. If a DMX signal is not present or becomes interrupted, the display will
flash until the DMX signal is present.

Slave Mode:

1.) Navigate the menu until you reach Run Mode, press <ENTER>.
2.) Use the <UP/DOWN> buttons to highlight Slave, press <ENTER>.
3.) The fixture is now in Slave Mode, and will follow the Master Fixture (the first
fixture in the DMX chain.)
4.) In Slave Mode, the starting DMX channel is shown prominently in the center of
the screen. If a DMX signal is not present or becomes interrupted, the display will
flash until the DMX signal is present.
Auto, Sound Active, & Manual Adjustments:
Allows a single or Master/Slaved units to run factory installed programs.

Auto Mode:

1.) Navigate the main menu until you reach Run Mode, press <ENTER>.
2.) Use the <UP/DOWN> buttons to highlight Auto Program 1 or 2.
3.) Press the <ENTER> button to confirm your selection.

Sound Active Mode:

1.) Navigate the main menu until you reach Run Mode, press <ENTER>.
2.) Use the <UP/DOWN> buttons to highlight Sound Active 1 or 2.
3.) Press the <ENTER> button to confirm your selection.

Static Mode:

1.) Navigate the main menu until you reach Run Mode, press <ENTER>.
2.) Use the <UP/DOWN> buttons to select Static Setup.
3.) Manual adjustments ranging from 0-255 can be made to any available static
mode submenu option.
Wink™ User Manual - Rev. A
Page 12
(c) 2017 Blizzard Lighting, LLC