Table of Contents
Advertisement
17.12.2
Calibrate Water Temp
Used to calibration on the Water Temperature sensor in the transducer.
17.12.3
Set Defaults
Restores the factory settings.
17.13 ALARMS
The Alarms menu allows you to define alarm settings for Shallow Alarm, Depth Alarm and
Temperature Upper/Lower/Rate.
To set an Anchor Alarm, enter in a shallow water and deep water value above and below
your actual anchoring depth. The alarm will sound when the depth becomes shallower or
deeper than the settings.
17.13.0
Shallow Water
Triggers an alarm when depth becomes shallower than the set depth.
17.13.1
Deep Water
Triggers an alarm when depth becomes deeper than the set depth.
17.13.2
Fish
The Fish Alarm can be set to detect and alert you depending on the size of fish. The options
are: Off, Small, Medium, Big and Huge. The alarm sounds if the set size (or bigger) is
detected.
17.13.3
Temperature Upper
Triggers an alarm when the transducer reports a temperature above the set temperature.
Page 144
Figure 17.13 - Alarms menu
CPF180i and CPF300i
Advertisement
Table of Contents
