Cleaning Your Fire; Metal Parts; To Clean The Inside Of The Window - Valor 5402 HOMESTYLE Owner's Manual

Turn the fire off and allow it to cool before attempting
any cleaning. Note that the fire will retain heat for
some time after it has been turned off.

Metal parts

Clean the metal parts with a slightly damp cloth and
then dry. Do not use abrasive cleaners, they could
scratch the surface.

To clean the inside of the window.

Before the window can be detached, the front units
will have to be removed as follows:
Models 5400 Ultimate & 5401 Colourway
See figure 5.
•
Remove the bottom front casting.
•
Lift the fire front casting clear. (Where applicable
by lifting the fire front casting up and forward to
release the locating screw heads at the back of the casting
from the keyholes in the surround sides.)
•
Remove the two screws securing the bottom of the front
surround to the sides of the convection box
•
Raise the front surround to allow the retaining lugs at
the top to clear the slots in the convection box hood and
then lift clear.
Model 5402 Homestyle
See figure 6.
The Homestyle front casting weighs around 20kg
(44lbs). To avoid any risk of injury, if you have any
doubt about your ability to safely lift this front, ask
someone to assist you.
•
Remove the bottom front casting by lifting slightly to
clear the locations at the top corners of the bottom casting.
•
Raise the front casting unit so that the bottom location brackets and the top location
plate are released from the locations in the main fire case then lift clear.
OWNER'S GUIDE

CLEANING YOUR FIRE

Page 9
Figure 5 Ultimate & Colourway
front removal
Figure 6 Homestyle front
removal