Ics Master Module; Fuses; Charging Fuse - Permobil C400 Service Manual

ICS Master module

ICS master module
The wheelchair seat may be equipped with an ICS
control system, and if so, the seat is controlled
from the system's ICS master module. This is
fitted in the wheelchair chassis.
m
WARNING!
The ICS Master Module must be configured for the seat
before being fitted. Detailed information on configuration is
provided in the technical manual for the ICS control system.
Removal
1. Raise the seat to the highest position. If the
chassis is equiped with fixed seat post, see
page 36. If the seat lift does not work normally
because the batteries are discharged or the
actuator is defective, the seat can be raised/
lowered manually, see page 28.
2. Switch off the main power switch on the control
panel.
3. Put the circuit breaker in the "OFF" position. It is
accessed through a hole in the chassis cover;
see page 43.
4. Remove the seat lift cover and the chassis
cover, see page 7.
5. Lift the ICS Master module out of its holder,
see fig.
6. Remove the lid from the ICS Master Module.
7. Clip the cable ties that hold the cables and its
electrical connections, being attentive to their
placement to facilitate subsequent refitting.
Fitting
Fit the SLS drive stage in the reverse order.
Replacing the Charging Fuse
The charging fuse is located in it´s holder on the
right side off the chassis, see fig.
1. Switch off the main power switch on the control
panel.
2. Put the circuit breaker in the "OFF" position. It is
accessed through a hole in the chassis cover;
see page 43.
m
CAUTION
Always make sure the main power switch on the control panel
is switched off before the circuit breaker is set to the "OFF"
position.
3. Remove the seat lift cover and the chassis
cover, see page 7.
4. Replace the blown fuse.
5. Refit in the reverse order.
The SLS-Drive Stage sits in its container
without fastening screws.
ICS master module with cover removed

Charging Fuse.

42