Slewing Brackets - Permobil C400 Service Manual

Slewing brackets

Slewing brackets
Removal
1. Raise the seat to the highest position. If the
chassis is equiped with fixed seat post, see
page 36. If the seat elevator does not work
normally because the batteries are discharged
or the actuator is defective, the seat can be
raised/lowered manually, see page 28.
2. Switch off the main power switch on the control
panel.
3. Remove the seat elevator cover, chassis cover
and the front fender on the side in question,
see page 7.
4. Lift up and chock up the wheelchair chassis
so that the wheel in question is free of the
ground.
5. Remove the front wheel, see page 10.
6. Disconnect the electrical connection for the
drive motor and the magnetic wheel lock. The
connections are positioned on the inside of the
chassis, on each side of the seat elevator/seat
post, see fig.
7. Disconnect the wheel lock release cable
8. Remove the shock absorbers front bracket,
see fig
The electrical connections of the drive
motors and the wheel locks are positioned
on the inside of the chassis, on each side of
the seat elevator/seat post.
The electrical connection for the drive
motor and the magnetic wheel lock.
The shock absorbers front bracket.
18