Permobil C400 Service Manual page 29

Seat lift
(Applies to older chassis models)
Removal
1. Raise the seat to the highest position. If the
seat lift does not work normally because the
batteries are discharged or the actuator is
defective, the seat can be raised/lowered
manually, see page 28.
2. Switch off the main power switch on the control
panel.
3. Put the circuit breaker in the "OFF" position. It
is accessed through a hole in the chassis cover;
see page 43.
4. Remove the seat lift cover and the chassis
cover, see page 7.
5. Remove the seat.
m
CAUTION
The seat is heavy. Two people should therefore lift it. Be careful
with the cabling.
6. Remove the seat lift. It is attached with four
screws, see fig.
The upper attachment screws are accessible
from the the battery boxes. Open the battery
covers and pull each battery out just enough
to get access to the screws through the holes
in the chassis.
7. Remove the ICS master Module. It is attached
with one screw, see fig. Disconnect the seat lift
cabling from the ICS General Module.
8. Lift the seat lift straight up out of the chassis.
Fitting
Fit the seat lift in the reverse order.
Seat lift's upper attachment screws.
Seat lift's lower attachment screws.
ICS General Module is attached with one screw.
29
Seat lift