Covers - Permobil C400 Service Manual

Covers

Removing the seat lift cover
1. Raise the seat to the highest position. If the
chassis is equiped with fixed seat post, see
page 36. If the seat lift does not work normally
because the batteries are discharged or the
actuator is defective, the seat can be raised/
lowered manually, see page 28.
2. The seat lift cover is mounted with four
plastic plugs which can be flipped up using a
screwdriver.
3. Remove the seat lift cover by lifting it
upwards/forwards.
Fitting
Fit the cover in the reverse order.
Removing the chassis cover
1. Raise the seat to the highest position. If the
chassis is equiped with fixed seat post, see
page 36. If the seat lift does not work normally
because the batteries are discharged or the
actuator is defective, the seat can be raised/
lowered manually, see page 28.
2. Remove the seat lift cover, see above.
3. Remove the two knobs on the front edge of
the cover, see fig.
4. Unscrew the knob at the far back of the
chassis cover, see fig.
5. Remove the chassis cover by lifting it
upwards/backwards.
m
CAUTION
If the chair is equipped with lighting, disconnect the rear-light
cabling at the connector fitted on the cabling.
Fitting
Fit the cover in the reverse order.
Removing the front fender
1. Remove the three screws, see fig.
2. Remove the front fender by lifting it
upwards/forwards.
m
CAUTION
If the chair is equipped with lighting, remove the chassis-
and seat lift cover. Disconnect the front-light cabling at the
connector fitted on the cabling.
Fitting
Fit the front fender in the reverse order.
The seat lift cover is mounted with
four plastic plugs.
The chassis cover is mounted with two knobs at
the front edge and a knob at the back.
The front fender is mounted with three screws.
7
Identification plates