Set Up Speakers - Denon AVR-1612 Manual

Set up speakers

Here we describe how to set up speakers other than 5.1-channel speakers.
For the method of setting up 5.1-channel speakers, see
First install and connect the speakers to this unit.
Before Auto Setup measurement, the settings shown below can be made.
• Changing the amplifier assignment (Pre Assign)
The signal output from the SURR.BACK/FRONT HEIGHT terminals on PRE OUT of the amplifier can be switched in accordance with the speaker environment
• Setting the channels to be used (Channel Select)
If channels that are not to be used are set in advance, measurement for the set channels is skipped, and measuring time can be reduced. You can also change the number of surround back speakers
"Set up "Channel Select"").
1
Set up the
remote control unit
n Set up the operation mode
AMP
Press to set the remote control unit to AMP-
operation mode.
Press AMP
BD
C page 4 "Setup wizard".
2
Connect the setup microphone.
When the setup microphone is
connected, the following screen is
displayed.
Audyssey Auto Setup
Preparation
Connect the speakers and place them according
to the recommendations in the manual.
Next
[ENTER] Enter
3
Select "Next", and then press
ENTER .
4
MultEQ
[RETURN] Cancel
40
around items indicate the settings.
(vpage 40 "Set up "Pre Assign"").
Set up "Pre Assign"
ui
Use to select "Pre Assign", and then press
ENTER .
Audyssey Auto Setup
Preparation
Set the following items
if necessary.
Pre Assign
Channel Select
Auto Setup Start
[ENTER] Enter [RETURN]
Pre Assign
Pre Assign NORMAL
[RETURN] Cancel
(vpage 41
MultEQ
Cancel
MultEQ
vSee overleaf