Denon AVR-1612 Manual page 28

STEP 1
Preparation
4
Connect the setup microphone to the SETUP MIC
jack of this unit.
When the setup microphone is
connected, the following screen is
displayed.
Audyssey Auto Setup
Preparation
Connect the speakers and place them according
to the recommendations in the manual.
Next
[ENTER] Enter [RETURN]
5
Select "Next" and then press
ENTER
.
6
ui
Use to select "Auto Setup Start" and then press
ENTER .
Preparation
Set the following items
if necessary.
Pre Assign
Channel Select
Auto Setup Start
MultEQ
Here, we explain setup using the example of 5.1-channel speaker
playback.
For settings other than 5.1-channel surround, select "Pre Assign"
and perform step 4 to 5 of "Set up "Pre Assign"" (vpage 40).
If unused channels are set with "Channel Select", measuring time
can be shortened. For setting, perform steps 7 to 11 of "Set up
"Channel Select"" (vpage 41).
Cancel
Audyssey Auto Setup MultEQ
[ENTER] Enter [RETURN] Cancel
13
Set up speakers (Audyssey ® Auto Setup)
STEP 2
Detect & Measure (Main)
• In STEP 2, you will perform measurements at the main listening
position.
• This step automatically checks the speaker configuration and speaker
size, and calculates the channel level, distance, and crossover
frequency.
It also corrects distortion in the listening area.
7
Select "Measure" and then press
When measuring begins, a test tone is output from each
speaker.
• Measurement requires several minutes.
8
The detected speakers are displayed.
• The illustration below shows an example of when the front
speakers, center speaker, subwoofer, and surround speakers have
been detected.
Audyssey Auto Setup
Detect Check
Front Yes
Center Yes
Subwoofer Yes
Surround Yes
Retry
Next Measure
[ENTER] Enter [RETURN]
NOTE
If a connected speaker is not displayed, the speaker may not be
connected correctly. Check the speaker connection.
9
Use ui to select "Next → Measure" and then press
ENTER
.
ENTER .
MultEQ
Cancel
vSee overleaf