Denon AVR-1612 Manual page 75

Setting items
Speaker Config. F.Height : Set the presence and size of the front height speakers.
(Continued) • Large : Use a large speaker that can adequately play back low
frequencies.
• Small : Use a small speaker that has inadequate playback capacity for
low frequencies.
• None : Select when the front height speakers are not connected.
NOTE
When "Pre Assign" setting (vpage 59) is "F.HEIGHT", you can make
the "F.Height" setting.
Bass Setting Subwoofer Mode : Select low range signals to be reproduced by
Set subwoofer and LFE subwoofer.
signal range playback. • LFE : The low range signal of the channel set to "Small" speaker size is
added to the LFE signal output from the subwoofer.
• LFE+Main : The low range signal of all channels is added to the LFE
signal output from the subwoofer.
• "Subwoofer Mode" can be set when "Speaker Config." – "Subwoofer"
(vpage 59) is set to "Yes".
• Play music or a movie source and select the mode offering the strongest
bass.
• Select "LFE+Main" if you want the bass signals to always be produced
from the subwoofer.
NOTE
If "Front" and "Center" for "Speaker Config." are set to "Large", and
"Subwoofer Mode" is set to "LFE", no sound may be output from the
subwoofers, depending on the input signal or selected surround mode.
LPF for LFE : Set LFE signal playback range. Set this when you want to
change the playback frequency of the subwoofer.
• 80Hz / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz / 200Hz / 250Hz
BD
Setting details Setting items
Distance Unit : Set the unit of distance.
Set distance from listening • Feet / Meters
position to speakers.
Step : Set the minimum variable width of the distance.
Measure beforehand the
• 1ft / 0.1ft
distance from the listening
• 0.1m / 0.01m
position to each speaker.
Default : The "Distance" settings are returned to the default settings.
• Yes : Reset to the defaults.
• No : Do not reset to the defaults.
When you select "Default" and press
the "Return settings to the default?" prompt
is displayed. Select either "Yes" or "No", and
press
Front L / Front R / Center / Subwoofer / Surround L / Surround R /
z
S.Back L
z When the "Speaker Config." – "S.Back" setting
to "1spkr", "S.Back" is displayed.
• 0.0ft – 60.0ft / 0.00m – 18.00m : Set the distance.
• The speakers that can be selected differ depending on the "Pre Assign"
(vpage 59) and "Speaker Config." (vpage 59) settings.
• Default settings :
Front L / Front R / Center / Subwoofer / F.Height L / F.Height R : 12.0 ft
(3.60 m)
Surround L / Surround R / S.Back L / S.Back R : 10.0 ft (3.00 m)
• Set the difference in the distance between the speakers to less than
20.0 ft (6.00 m).
NOTE
Speakers set to "None" in "Speaker Config."
displayed.
60
Setting details
ENTER
,
ENTER
.
z
/ S.Back R / F.Height L / F.Height R : Select the speaker.
(vpage
(vpage
System Setup
59) is set
59) are not
vSee overleaf