Denon AVR-1612 Manual page 88

5
Pressing ui, select the first letter of the device
brand name. Then press ENTER .
RemoteSetupGuide
[1/4]
Please select the
1
first letter of the
A
brand name
B
of the device.
C
D
DVD
E
[CH+/-]Page+/-
• The first character is displayed as 1, A to Z.
(Initials for the brand are displayed for each
category.)
For brand names that start with numbers
and symbols, select "1".
• When there are several pages of brand
names, the pages can be switched by
CH +
pressing the remote control unit's or
CH –
.
6
Pressing ui, select the device
brand name. Then press ENTER .
RemoteSetupGuide
Please select the
Dantax
brand name.
Denon
Disney
DSE
Durabrand
DVD
• When there are several pages of brand names, the pages can be
switched by pressing the remote control unit's
NOTE
If the desired brand name is not listed, the supplied remote control
unit cannot control the device. Use the remote control unit supplied
with the device to be used.
7
The procedures for registering remote control codes
and remote control preset registration are displayed.
Device
Brand
Code
[QUICK1]
NOTE
If a wrong brand name is selected, press
following screen is displayed:
AMP ENTER
Press then
8
Press the input source button on which the preset
code is to be registered (
V.AUX DOCK
,
TV
• For , only the preset code for the categories "TV", "TV/DVD", or
"TV/VCR" can be registered.
9
Press and hold
CH + CH –
or .
The indicator flashes twice.
RemoteSetupGuide
DVD
Denon
30490[1/3]
1.Press[INPUT SOURCE].
2.Press and hold [DEVICE ON(I)]
for 3 seconds.
3.Input Code with [0-9].
4.Press any key to check device.
OK [QUICK2] NG [QUICK3] Return
QUICK SELECT 3
. The
RemoteSetupGuide
Press [AMP] button. And press
[ENTER] button to return Brand
select menu.
O K
to return to step 6.
BD , SAT/CBL , TV , DVD
GAME
or ).
DEVICE Z for at least 3 seconds.
73
10
Enter a five-digit code using 0 – 9
Press the buttons with an interval less than 10 seconds.
RemoteSetupGuide
Device DVD
Brand Denon
Code 30490[1/3]
1.Press[INPUT SOURCE].
2.Press and hold [DEVICE ON(I)]
for 3 seconds.
3.Input Code with [0-9].
4.Press any key to check device.
[QUICK1] OK [QUICK2] NG
• When the code is registered.
The indicator flashes twice.
• When the code is not registered correctly
The indicator slowly flashes once. Perform from step 8 again.
• When an input number is not correct
ON
Press once then perform the operations from step 8 again.
11
Operate the device being used to check the operation.
QUICK SELECT 1
• If the device is operating, press
Go to step 12.
• If the device is not operating, press
Go to step 13.
12
The screen shown below is displayed, and registration
of the preset code is completed.
RemoteSetupGuide
,
Remote Setup Guide is finished.
Press [AMP] button. And press
[ENTER] button to return MENU.
O K
AMP
• The menu screen is retrieved. Press
Registering preset codes
.
[QUICK3] Return
.
QUICK SELECT 2
.
ENTER
then .
vSee overleaf