Denon AVR-1612 Manual page 76

Setting items
Channel Level Test Tone Start : Output test tone.
Set the volume of the test • Front L / F.Height L / Center / F.Height R / Front R / Surround R /
z
tone to be the same when it / S.Back L
S.Back R
is output from each speaker. z When the "Speaker Config." – "S.Back" setting
to "1spkr", "S.Back" is displayed.
• –12.0dB – +12.0dB (0.0dB) : Adjust the volume.
When "Channel Level" is adjusted, the adjusted values are set for all the
surround modes. To adjust the channel level separately for the different
surround modes, use the operation see page 44.
NOTE
• Speakers set to "None" in the "Speaker Config."
settings are not displayed.
• When a headphones jack is inserted in the PHONES jack of this unit, the
"Channel Level" is not displayed.
Default : The "Channel Level" settings are returned to the default settings.
• Yes : Reset to the defaults.
• No : Do not reset to the defaults.
When you select "Default" and press
the "Return settings to the default?" prompt
is displayed. Select either "Yes" or "No", and
ENTER
press
BD
Setting details
z
/ Surround L / Subwoofer : Select the speaker.
(vpage
(vpage
ENTER
,
.
Setting items
Crossover Freq.
Set the maximum frequency
of the bass signal output
59) is set from each channel to
the subwoofer. Set the
Crossover Frequency to
suit the bass reproduction
capability of the speaker
being used.
59)
61
Setting details
Crossover : Set the crossover frequency.
• 40Hz / 60Hz / 80Hz / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz / 200Hz /
250Hz
Advanced : Specify crossover frequency for each speaker.
• Front / Center / Surround / S.Back / F.Height : Select the speaker.
• 40Hz / 60Hz / 80Hz / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz / 200Hz /
250Hz : Set the crossover frequency.
• "Crossover Freq." can be set when the "Bass Setting" – "Subwoofer
Mode" (vpage 60) setting is "LFE+Main", or when you have a
speaker that is set to "Small".
• Always set the crossover frequency to "80Hz". When using small
speakers, however, we recommend setting the crossover frequency to
a higher frequency.
• For speakers set to "Small", sound below the crossover frequency
is cut from the sound output. The cut bass sound is output from the
subwoofer or front speakers.
• The speakers that can be set when "Advanced" is selected differ
depending on to the "Subwoofer Mode" setting (vpage 60).
• When "LFE" is selected, speakers set to "Small" at "Speaker Config."
can be set. If the speakers are set to "Large", "Full Band" is displayed
and the setting cannot be made.
• If set to "LFE+Main", this setting can be made regardless of the
speaker size.
System Setup
vSee overleaf